Steel Parts We Machine
Ten steel part families from fixture plates to hardened wear inserts, with the heat treatment route each one usually carries.
Ten Part Families We Run Repeatedly
| Part family | Common materials | Key tolerances | Typical finish | Typical order |
|---|---|---|---|---|
| Mold cores and cavities | P20, 718H | +/-0.01 mm parting lines, polish-ready Ra 0.4 | Pre-hardened as supplied | 10 to 50 pcs |
| Ejector and clamp plates | 1045 | Flatness 0.02 mm over 300 mm | Black oxide | 10 to 100 pcs |
| Jig and fixture bases | 1045, 4140 | Bores +/-0.01 mm, flat 0.02 mm | Black oxide or QPQ | 10 to 100 pcs |
| Gear blanks and gears | 4140, 20CrMnTi | Pitch diameter +/-0.01 mm | Carburized or induction hardened | 200 to 2,000 pcs |
| Heavy duty shafts | 4340, 42CrMo | Journal +/-0.005 mm after grind | Quench and temper, ground | 50 to 500 pcs |
| Hydraulic manifold blocks | 1045, 4140 | Port position +/-0.02 mm, pressure tested | Black oxide / zinc plated | 50 to 300 pcs |
| Wear inserts and guide blocks | D2 | HRC 58-62, ground faces | Hardened and ground | 50 to 500 pcs |
| Stamping die components | D2, Cr12Mo1V1 | Cutting edge +/-0.01 mm | Hardened, wire EDM cut | 20 to 200 pcs |
| Sensor and switch housings | 1018, 1045 | +/-0.05 mm general | Zinc plated, RoHS compliant | 1,000 to 10,000 pcs |
| High temperature fixtures | Inconel 718 (GH4169) | +/-0.02 mm, solution and aged | Aged, bare | 5 to 50 pcs |
Grade data: steel grade comparison. Treatment routes: heat treatment standards.
Worked examples with full measurement data: case studies.
Get a quote in 24 h Inspection & QC Tolerance standards
Frequently Asked Questions
Can you quote steel parts with heat treatment included?
Yes, we quote the full route: machining, treatment at audited partners, finishing and certificates, as one order with one point of accountability.
What is your minimum order on steel parts?
No MOQ. Fixture and die components often run in single pieces or small sets; production families run in repeat batches.
Do you plate or coat steel parts after machining?
Zinc, nickel and black oxide are coordinated per drawing with RoHS and REACH declarations available.
Send Your Drawing
Quote with engineering feedback within 24 hours; prototypes in 7 to 15 days.
Request a Quote